3. Installation of Radonix CAM-Pro X.X.X Software

If you do not already have the Radonix CAM-Pro X.X.X software installed (where X refers to the latest version), you can request the latest version using the contact information below:

ℹ️

Information
The Radonix CAM-Pro application is currently available only upon request. To obtain the latest version, please contact: 📞 +90 553 920 5500 📧 [email protected]

Once you've downloaded the Radonix software, double-click the downloaded file and follow the steps below:

If you would like to change the default installation path and select a custom location for the software, proceed with the setup steps shown in Figures 19 and 20.
If you do not want to change the default path, you may skip to Figure 21 or the fifth step listed next to the figure.

In Figure 20, select the desired installation location and click the "OK" button.

Continue the setup with the following steps:

✅ The software has now been successfully installed.

ℹ️

Note
If this software is already installed on the user’s computer, you can skip the installation steps by starting directly from Figure 25.

---

Once all listed software components have been installed, the final step is to install the correct interface according to the device you will be using the Radonix control board with.
For detailed information about the interfaces and their features, please refer to Section 4.